Hey Bob,
Ok, now I am still confused. Some facts I should have stated.
1. My 3 is a negative ground car.
2. My Facet pump is only for negative ground cars.
3. The black wire on the pump comes with an eye connector for grounding
already on the black wire. The instructions show black as ground.
4. The instructions indicate attaching the red to the newly installed oil
pressure switch "P" terminal. (No oil pressure installed). Which indicates
to me positive.
5. The harness white wire goes to the "Neg" side of my coil.
6. The "Neg" terminal of the coil goes to the distributor.
Does this help?
Alex
----- Original Message -----
From: "Bob" <yellowtr@adelphia.net>
To: <triumphs@autox.team.net>
Cc: "Alex" <ambritts@bellsouth.net>
Sent: Saturday, December 27, 2008 11:41 AM
Subject: Re: [TR] Facet Pump
> On Saturday 27 December 2008 11:22:05 Alex wrote:
>> Well its Sat morning and the Facet pump is being installed on my 59 TR3A.
>> Needed to get the fittings and filter which I now have. In short order I
>> will be wiring it up. Great instructions on wiring to the hot side of the
>> coil or white wire. So what's the problem? The wire from the harness is
>> white and the replacement TRF coil wire to the distributor is white. So
>> which one is considered hot. From the harness it comes from the ignition
>> switch which could be considered hot. Or from the coil to the distributor
>> could be considered hot. Any help on this one would be appreciated.
>> Alex Manzo
>> 59 TR3A
> Alex,
>
> The white wire off the harness is ignition switch HOT.
>
> On a + ground TR, that wire goes to the - terminal of the coil.
>
> If you have a spade coil, you should have 2 male space terminals at the
> coil.
>
> Connect the - (black) wire from the facet pump to the terminal of the
> coil
> where the white wire attaches coming off the harness. The wire that goes
> to
> the distributor may also be white but will be attached to the + side of
> the
> coil. Dont hook up the pump hot wire to this side. I put a fuse between
> the
> lucar terminal to the coil and the pump just to be safe.
>
> Also remember to connect the red facet wire to a good ground as the pump
> body
> is not grounded. That allows the pump to be used on both - and + ground
> systems.
>
>
> I have the facet pump system working on both my 3 and 4 and will have the
> same
> pump on my 6 when that car is finished in about 2 to 3 years time.
>
> Bob
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|