> -----Original Message-----
> From: Dave1massey@cs.com
> Subject: Re: [TR] Need method for welding floorpans
>
> It's like dij` vu all over again.* I get to answer this again.
>
> Sure this is a good place for this product. A better place is
> in the joint so if you haven't already welded the pieces
> together run a bead immediately before welding (test fit dry
> first) and weld away. But on seams already welded applying
> this on the outside works well, too.
On second thought, is there any need to weld a floor pan on
the TR2 through TR6? Perhaps this would be a good place to
use adhesive alone.
My apologies if this was already discussed ad nauseum.
-Mark
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|