> -----Original Message-----
> From: Dave1massey@cs.com
> Sent: Monday, January 08, 2007 9:54 AM
> Subject: Re: [TR] Need method for welding floorpans
>
> When you consider that seam welding is a much longer
> process than spot welding it is logical to assume that
> they were spot welded. In the same manner the TR6
> inner and outer sills both have flanges that are spot
> welded together and the joint is covered by the draft
> excluder that clips on over the protruding edge.
> Fast, efficient and good enough.
I wonder whether this might be a good place to use one
of the high-tech adhesives that have been discussed
here recently? Tack weld the floorpan to the sill as
original, then use adhesive to bond the upper edge to
the sill.
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|