Larry:
I also wrote this article and have done it many times (how else
do they get the o-ring seal on the adjusting screw). If I recall,
Victoria British sells the o-rings (sorry, I'm painting my room that
has all my Triumph catalogs, etc. and they are in boxes under
covering.
If you have further questions, please feel free to contact me off
line from the list.
Scott Suhring
Elizabethtown, PA
'70 TR6
'59 TR3
lstein6@earthlink.net wrote:
>
> i have the cd150se carbs on my gt6. as part of the rebuild process (again!)
> the vtr web site has some great instructions. my oil dampers leak bad. vtr
> has a tech tip that explains to remove the needle from the air valve, then
> driving out the needle adjusting screw with a 8 1/2" rod by hitting it with a
> hammer. has anyone done this ? i've got it all apart and tried one decent
> tap with the hammer. i dunno !!! it was really tight and i don't want to
> break anything here. advice is greatly appreciated by anyone who has done
> this before. also, i don't have seals in my carb rebuild kits from trf (is
> says that in this ttech tip too, so now i am getting real doubtful).
> larry lstein6@earthlink.net
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
/// or try http://www.team.net/cgi-bin/majorcool
|