Today installed camshaft and bearing, and measured end float. Spec says
.003 to .0075, or possibly .004 to .0075, depending where you look. I'm a
bit out though, at .228"
What am I missing here? What prevents the cam from moving backwards?
(That's where all the extra play is.)
I see from wear on the cam sprocket that it was doing the job of keeping
the cam forward, yet Haynes clearly specifies measuring float before the
sprocket is in place.
Thanks,
Jim
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
/// or try http://www.team.net/cgi-bin/majorcool
|