Hi Curt
I know that your using the Vizard book as a guide but without a flow bench
this tip might help you a little. Shine a flashlight into the hole in the
direction of the gas flow, remove the shadows or at least cut them down to a
minimum. then change the angle of the light. It is rather crude but it works
when you have little else. I hope you don't mind the tip.
Regards
John J Black
Waterloo Drivetrain Systems
www.waterloo-dtr.com
-----Original Message-----
From: owner-spridgets@autox.team.net
[mailto:owner-spridgets@autox.team.net]On Behalf Of
curt.onstott@orst.edu
Sent: Tuesday, April 11, 2000 11:08 AM
To: spridgets@autox.team.net
Subject: Playing with my new die grinder...
I've had Vizard's book for a few years and finally decided to try modifying
my
cylinder head. Here is a picture of what I've done so far-- I might have
taken
a little too much off of the guide boss on the right port. The one on the
left
is untouched. This is the link:
http://crackhead.baba-booey.com/intake_bowls.jpg
Curt Onstott - Crop and Soil Science Computing Admin
Oregon State University. - (541) 737-5875 - Office: CrpS 153b
http://www.css.orst.edu/curt
No, life IS a contest. Perhaps it doesn't FEEL like a contest to YOU
because I WON so long ago. -Voorhis
'70 MG Midget '75 Jaguar XJ6 '95 Specialized RockHopper
|
