To the list
I have had an external oil feed line for several months (given to me by a
person who sold his TR6 but had never installed it). Since the engine has
now been rebuilt, I would like to install the oil feed line before replacing
the rocker shaft. Problem is no instructions. Cylinder head end looks
simple; remove the bolt at the left rear corner. Block has two
possibilities: 1) oil pressure relief valve, 2) oil pressure switch. If it
does mount to the oil pressure relief valve has anyone had problems with
clearance with oil cooler lines coming off a spin on filter adapter? The
lines on my TR6 have the metal fittings that run to where the pressure
relief valve is sitting.
Frank
'76 TR6 CF57005U
|