On Tue, 27 May 1997, Jack I. Brooks wrote:
> Does anyone have any measurements for the seat belt anchoring locations used
> on the TR3B or TR4's? I am pretty sure the TR3B has anchor plates on
> transmission tunnel and wing liners. I would like to get some dimensions,
> so that even though they are not "correct" for my TR3A, they are at least in
> the right location.
>
> Also any details about how the belts are attached and how they pass through
> the carpets and trim would be appreciated.
Jack, I have at home some original, on-factory-authorized-distributor-
letterhead some Standard-Triumph service bulletins that address this exact
question. They included full-size templates, which are ok except that they
were hand-drawn done for "ditto" reproduction (boy, those were the days,
eh?). However, I think some measurements are given as well.
These bulletins were aimed particulary at Connecticut dealers due to state
regulations that took effect there circa 1962.
If interested, I could photocopy them for a SASE!
--Andy
* * * * * * * * * * * * * * * * * * * * * * *
* Andrew Mace, President and *
* 10/Herald/Vitesse (Sports 6) Consultant *
* Vintage Triumph Register *
* amace@unix2.nysed.gov *
* * * * * * * * * * * * * * * * * * * * * * *
|