Re: tr6 fan belt

[JoeSimcoe@aol.com]

<<I find it easier is
loosen the engine mounts on one side and then jack up the engine (a small
amount is all that is necessary) using a bubble jack>>

I just replaced the engine mounts on my 74TR6 - While I was at it I changed
the fan belt 'cause I had the engine jacked up anyway.    When I was done, I
found that the new mounts raised the engine up enough that I could fit the
belt through there.  At least until the new mounts sag as much as the old
ones were !!!

JoeSimcoe