Chris,
Joe IV gave you the same advice that I was going to -- all I would add to
his post is that there are two plastic plugs that these wires go into before
the plugs push onto the backs of the alternator.
Thee Brown/Yellow and Brown/Green wires go to the smaller of the plugs,
the heavier gauge Brown/White and Black (GND) wires go to the larger plastic
plug.
There is also 3 additional wires that come out of the harness at the same
spot as these wires. They go straight to the coil in the following manner.
Green/Blue goes to - side of coil
White/Brown goes to + side of coil
White goes to + side of coil.
I have not looked at where these go back to - as someone else posted that
info to you. However if you have an original harness, or can trace any
splices back to original wires, this color code should help you.
JoeSimcoe
|