In a message dated 96-08-28 20:05:48 EDT, you write:
<< Well I got that corrected
and then went to install the 38 inch used drive shaft I bought, this is the
dimension that the John Kipping catalog says is needed (the non O/D shaft
is 41.25 inches). Quess what? It did not fit!!! I measured the distance
between the diff flange and the tranny flange and get 37.5 inches. Arghhh!!
>>
Ralph,
Uhhh, that happened to me a few years ago. Try loosening all 4 of the motor
mounts - 2 engine, 2 tranny. There's about 1/2" worth of play there.
Give it a shot,
Charlie B.
|