Paul,
Trying to remove an easy out with a drill bit might be a big challenge. Easy
outs are harder than most drills, not withstanding carbide. You haven't
said what size the broken stud is; if it's small (like less than 1/4 inch) I
have had good luck using a Dremel tool with diamond bits (burs) (Harbor
Freight, like item #36252-1ADH) use lots of cooling fluid. In fact you could
use that super duper penetrating combo of ATF/acetone (50/50 mix) that guys
were talking about a while ago. Just don't get it so hot that the acetone
ignites. HA. That might even make getting the stud out easer also. You
could also use WD-40; the main thing is to keep the tool cool.
If the stud is bigger you could still use a bur it would just take longer.
Good luck
Jerry Christopherson
9473187
-----Original Message-----
From: tigers-bounces@autox.team.net [mailto:tigers-bounces@autox.team.net]
On Behalf Of Paul.Tonizzo@sybase.com
Sent: Monday, August 17, 2009 8:27 AM
To: tigers@autox.team.net
Subject: [Tigers] easy outs
Do you have a web source for left-hand drill bits? I have never had luck
finding them.
thanks,
Paul
> From: "Clyde McLaughlin" <clydemclaughlin@verizon.net>
> Subject: [Tigers] easy outs
> To: <tigers@autox.team.net>
> Message-ID: <004601ca1ddf$229c46a0$0201a8c0@chesapeake4>
> Content-Type: text/plain; charset="us-ascii"
>
> If any one has these in there tool box through them away, buy a left
hand
> set of drill bits, a quality high speed carbide bit will remove it, but
it
> takes awhile, Clyde
You are subscribed as jcmc2006@suddenlink.net
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|