Ron,
At one time I actually had a dual 5-Bolt/6-Bolt housing. I presume it was a
Ford item, but I'm not certain. It was certainly not made of cast iron,
just cast aluminum. I tried searching the Web for an answer and my search
engine says there might be such a part in the following parts swap forums.
I wasn't motivated enough to peruse them though.
Here are some places to look.
http://www.mm.com/swapmeet/others/fordpart.htm
http://www.hotrodsworldwide.com/ford.htm
John doesn't seem to be asking IF there's such a bell housing and he's
pretty specific about "ford truck cast iron", so I assume he has some
specific knowledge that such an item does exist - right John?
Bob
At 09:15 AM 9/1/00 -0400, you wrote:
>John
> I don't think FORD ever made a bellhousing that will fit both a 5
>and 6 bolt engine. FORD made a bellhousing with a dual bolt pattern for
>the transmission and I have never identified that part number.
>
> Here is a list of FORD bellhousings:
>
>5 bolt C3OZ - 6392C
>5 bolt scattershield C4OZ - 6394A
>
>6 bolt C5AZ - 6392A
>6 bolt C5DZ - 6392A
>6 bolt scattershield C5ZZ - 6394A
>Ron Fraser
>
>-----Original Message-----
>From: John Brawley [mailto:johnjb_44@hotmail.com]
>Sent: Saturday, August 26, 2000 8:21 PM
>To: tigers@autox.team.net
>Subject: 5-bolt/6-bolt cast iron bellhousing--Part ##??
>
>
>Group,
>
>Does anyone know the part # for the ford truck cast iron bellhouing for both
>
>5 and 6 bolt blocks????
>
>Any help would be appreciated.
>
>Regards, John
>________________________________________________________________________
|