Chris, let me give you another view to DOT 5 "Silicone" brake fluid.
DOT 5 will not harm your paint, and doesn't absorb water, like DOT 3 or 4.
DOT 4 Must be bleed out of the entire system, before using DOT 5 or you
will get soft spongy brakes.
DOT 5 will let water in the system, and then because it is heavier than
DOT 5 it will go to the low points, which could be the brake lines,
which if are old, and no longer have a protective coating will rust from
the inside. Looks great on the outside, but.
DOT 5 fluid is not used in racing cars, even though it has good heat properties.
I used DOT 5 once in a Vette, and did not know this and had soft brakes,
even though I bleed the brakes repeatedly.
Brake bleeding is not that hard, and can be done by one person. There
are 2 systems that work great for bleeding yourself.
E-Z Bleed uses low pressure, tire pressure at 5-15 lb., with a resiovor
of fluid, and pressurizes the system through the master cylinder. You
open the bleed valve at each wheel and you are finished. One of my cars
requires bleeding 1/yr and it takes me 30 minutes. Most of the time
jacking up the wheel and taking off the tire.
There is a another system that is sold by several people, which uses a
spring loaded ball at the bleeder fitting, and you pump the brakes, and
the ball prevents air from coming into the system.
Brake Fluid is cheap, and with a little experience bleeding the lines
takes no more time than changing the oil.
Larry
|