Chris Pappathopoulos wrote:
>
> Is there a source in the states for an accelerator cable that will work
> with twin SU HS4s? Will a cable from an HS2 equipped car work, or is the
> linkage different between the two setups? The cable on the car with the
> Strombergs will not work becaase the cable sticks out too far past the
> outer covering.
>
> Thank you,
> Chris Pappathopoulos
Chris,
My question would be, "What car equipped with HS2's used a cable. All
the US ones had the rod that pushed the linkage between the carbs up
from below.
That being the case, I fabricated a bell linkage from drawings in the
Haynes manual to create a place to mount a cable that was made for US
1500's (single ZS). I had to clip the end off the cable and install a
different style of end so that I could adjust the cable.
Joe
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|