Re: screwed...

[Thearthurhsmith@cs.com]

In a message dated 3/6/00 12:08:57 AM Eastern Standard Time, jmcneal@ohms.com 
writes:

> IS there a simple, clever way to rig up a portable drill press so I can
>  drill straight down without worring about drilling crooked?  Or should I
>  just say "screw it" and use the alternate hole that the PO drilled, even
>  though it interferes with the travel of the sliders?
> 


YES, yes you are screwed. Use the DPOs hole. You can't drill taps out with 
ordinary drills. I am experienced at trying and failing.