Went in to Mill hill tools in Didcot today and had a look at there most
basic model. An SP, it was 90A and could weld from 0.4 to 4mm of mild
steel. It seemed to have a high low switch and a min max switch. Three
current settings. And some special frequency gizmo for low currents to make
the weld better? Anyway that was going to be 200 pounds all in.
What do thoes switches do. Some of the clark ones seem to have a 1-A 2-3
Min-Max switches.
Just to say I am in South Oxfordshire, and have the Thames Valley Free
Advertiser with three ammiture welders. A new MIgmate for 100 quid, in
andover. A 120 amp machine for 85 pound in bracknell, and a migty mig 100XT
turbo for 145+ quid which I think is a bit much, but that was in swindon.
All but the swindon ones a a fair treck.
Any Ideas, or should I wate for the next issue.
Mabe If I keep on pestering people someone will give me a welder for free!
PS therse an advert for a tonnue cover for a spit new for 20 quid in it,
can't find it again in the car section.
James C
|