Just a note here,,,,
I lost a real good friend of mine to a 57 chevy in College.
He had the thing up in the air using cement blocks, wheels off removing the
tranny.
During the pushing and pulling the blocks gave way and crushed him under the
frame. His roomy found him the next day.
DON'T GET UNDER ANY CAR WITHOUT THE CAR ON STANDS !!!
Good job Atwell, you do good ASCI II
-----Original Message-----
From: Atwell Haines [mailto:carbuff@nac.net]
Sent: Thursday, May 06, 1999 11:48 AM
To: Neil McAllister; Roger Elliott; Spitfire
Subject: Re: Front Spoiler
At 11:49 PM 5/5/99 GMT, Neil McAllister wrote:
>
>Hi Atwell,
>
>Could you please describe this valence you mention.
OK here goes. First, assume you are lying on your back under the car,
with your head towards the front. (Not that uncommon for most of us, is
it?) Under the factory spoiler (or more accurately, air dam/kerb feeler)
are five bosses that receive the valence mounting hardware.
Towards the rear of the car, under the bottom of the slanted radiator, a
metal reinforcement (similar to those along the top of the side valences)
runs along the valence edge. On the left and right sides of the valence,
vertical 'walls' are folded in. These provide stiffness, and also allow
the valence to be fastened to the frame rails on either side, with four
largish sheet-metal screws (you will see the holes).
So if you could step back and look, the valence can loosely be described as
a peacock-tail shaped thing.
[OK you can get out from under the car now. Hope you didn't get too
greasy!]
Let me know if you need a better description. I warn you, I am WORTHLESS
at ASCI II art!
+++++++
The metal crossframe you mentioned is actually ABOVE the position of the
air dam. Also, each of the holes in my frame have rubber plugs inserted
into them...I'm sure to keep moisture & corrosion out!
Sincerely,
Atwell Haines
Neil Asked:
>Until recently, I didn't
>realize that Emma Peel (1980) was missing a spoiler at all - it's not so
obvious
>on the rubber bumper cars. I've been looking around for one here in BC
with
>no luck so far, but now wonder if I'm missing more parts (like a valence).
>Below my current bumper is metal crossframe with three holes in it. This
is
>painted the original colour.
>
>Thanks,
>
>Neil
>1980 Spitfire (Emma Peel - not spoiled, but definetly pampered)
|