Re: [Shop-talk] coupling two shafts

[John Miller <jem@milleredp.com>]

> http://www.clubfte.com/users/jniolon/connector.jpg
>
> the 3/4 male end would fit into the gear drive and the 1-9/16 female
> would slide over the shaft of the engine stand head... haven't gotten to
> the tightening part yet... maybe set screw on a flat portion of the
> shaft ???

Okay, then come up with something like that.  RPM/balance doesn't seem 
to be a factor.

If you want to be neat it looks like a piece of 2in solid bar stock with 
a 3/4in hole in one end and a 1 9/16in hole in the other.   Keyway 
machined in one end (presumably with a threaded set-screw hole at 90 
degrees or something) and you're probably going to use a through-bolt or 
a big roll pin in the other.

I'm guessing the guy who does my one-off machine work would want $75 to 
do that.

Failing that, you might be able to weld together some combination of 
pipe fittings and etc.

A motorized engine stand?  Must be a scale of engine I don't deal with...

John.
_______________________________________________

Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.96
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums