The big question, already asked, is how much torque and what RPM?
If you have low torque and low ROM, just hose clamp a stiff, wire reinforced
hose on both ends. It's been done before.
Jack
-----Original Message-----
From: shop-talk-bounces@autox.team.net
[mailto:shop-talk-bounces@autox.team.net] On Behalf Of John Niolon
Sent: Saturday, January 08, 2011 12:51 PM
To: shop-talk
Subject: [Shop-talk] coupling two shafts
current project is attaching a gear drive to a shaft...
the output shaft of the gear drive is 3/4" and keyed
the other shaft is smooth and 1-9/16" diameter.
or course they have to be coupled end to end
I think what I'm looking for is a 'motor coupler" but can't seem to find
one
that is female on each end. The 1-9/16" shaft is permanent and unmovable...
I'll have to fabricate a mount for the gear drive so it can be anywhere...
do they make a female/female-keyed coupler in my sizes that you don't have
to
be The Donald to buy ??? suppliers ??? other suggestions
thanks
John
I've learned in life that my primary goal
is to serve as a bad example
_______________________________________________
Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.96
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/shop-talk/jibjib@att.net
_______________________________________________
Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.96
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|