shop-talk
[Top] [All Lists]

Re: [Shop-talk] Basic MIG Welding questions

To: Marc <smarc@smarc.net>
Subject: Re: [Shop-talk] Basic MIG Welding questions
From: Mark Andy <mark@sccaprepared.com>
Date: Wed, 4 Feb 2009 11:03:29 -0500 (EST)
Howdy,

On Mon, 2 Feb 2009, Marc wrote:
> Well, there's a purge setting on the 180, which is basically just a wire 
> feed speed of 0. I use the purge setting to set gas flow without wasting 
> wire. Maybe you could rig up a switch to open the circuit to the feed 
> motor...

My lincoln SP175Plus has a purge setting.  You activate it by flipping the 
feed roller clamp up.

:-)

Mark
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


Shop-talk mailing list

http://autox.team.net/mailman/listinfo/shop-talk

http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>