--- On Mon, 2/2/09, Jim Stone <jandkstone99@msn.com> wrote:
> Not as far as I can tell. The owner's manual
> doesn't indicate anything about
> purging per se, but here's how it describes setting the
> gas flow rate:
>
> Flow Adjust
> Flow rate should be set when gas is
> flowing through welding power
> source and welding gun. Open
> feedhead pressure assembly so
> that wire will not feed. Press gun
> trigger to start gas flow.
>
> I could be wrong, but I assume that a purge valve could be
> used here, if the
> 140 had one.
I teach my welderettes (I've found women to be superior welders, once trained)
to keep the feed roll pressure to a minimum. Rollers slip when the wire hits a
surface not connected to the work cable and gas purges the cablehose. And
absolutely no birdnesting of the wire. As always, YMMV.
Charlie
#71 MiDiv F500
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|