I would add to all that: Do not overlook the contact area between starter
and block/bellhousing. If it is a RCH loose and maybe has some oil between
the surfaces, the ground will be poor, or at best intermittent.
Rex Burkheimer
> Make sure the connections to the battery are clean and tight. Remove both
> cables and wire brush any corrosion off, then coat them with vaseline
before
> putting them back on the battery. Now, don't forget the other ends of the
> cables. Check the other ends for clean, tight connections at the ground
and
> at the starter relay. Check the cable from the relay to the starter.
> etc
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/shop-talk
|