I am attempting to "remanufacture" four of the interior panels in the TR3
and purchased a sheet of 1/8" masonite for the base. Every time I try to
cut it with the reciprocating saw or the sawzall it either rips or the edge
"balls up" and makes a sloppy cut.
Does anyone have a good suggestion to make these cuts, particularly the
curves. I seem to get a nice cut with a circular saw and a very thin blade,
but this will not work on the curves.
TIA
kengano@advant.com
downstate illinois
1959 TR3A TS57756L
1958 Model 10 Sedan TBE9239LDLB
|