I started to install my Olds 4-3/TH-350 in my '55 1st. Chevy 3100. As i was
positioning the combo in the frame. I was raising the tailshaft to get the
TH-350's pan surface paralell to the ground. When I thought it looked about
right, I climbed out to check the carb throat to see if it was horizontal.
It wasn't.
Question:
How are you supposaed to position the engine to get the carb setting the way
it should? I always thought you wanted the carb throat surface to be
horizontal. But, if the TH-30's pan surface isn't paralell to the ground,
won't this cause problems?
Any feedback will be appreciated.
====================
Mark Self
Redlands, CA
'55 1st 5-window 3100
"Sentimental Journey"
====================
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|