Where did he get .010 as the setting for the 1800? That's not what I've been
using... Seems awfully tight.
on 10/21/01 12:47 PM, swillis at swillis@premiernet.net wrote:
> I am getting a rattle that sounds like it is valve noise. I set my MGA 1500 to
> .017" warm and still made noise. Now I set it to .015". The ticking is gone
> but there is a loose rattle sound coming from the generator side of the motor,
> kinda towards the front. I remember my water pump made a similar noise when it
> went out on my MGB, but there is no play in the fan on this car and no leak. A
> local mechanic said I could have a cracked piston or loose wrist pin. My oil
> pressure is great. The local MG guru (who drinks a bit. Ya gotta love this
> guy, great mechanic but hard to motivate) said it's valve noise. Said to
> tighten the valve to .010". Said he always does. That's the B 1800 setting.
> Same motor. No problems. I'm a little paranoid to set them that tight. Any
> suggestions? Really sounds like something flopping around in there. Almost a
> dieseling sound. Heard best at idle. Doesn't seem to get louder when revved.
> Actually gets drowned out.
> Cheers,
> Scott
> 59 MGA
> 73 Bonnie
>
--
Max Heim
'66 MGB GHN3L76149
If you're near Mountain View, CA,
it's the primer red one with chrome wires
///
/// mgs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
///
|