Stupid question time. I drilled the center out of some screws today - the
heads are easily knocked off with a hammer and a screwdriver, but I can't
get the rest of the screw out, whats left of the threads are hanging on for
dear life. How do you finish off the job? I tried whacking it from the
side to try and collapse the hollow screw but that didn't work. I could
try moving to a bigger bit, but its very difficult to drill down the exact
center so then I'd be taking out part of the hole too.
Thanks
Skye
Still learning the basic stuff
--
1966 MGB GHN3L-70307 __,__\__ Finger for
The MGB Experience http://www.mgb.bc.ca/ (_o____o_) PGP key
|