Carl,
You run 1 1/2 inch SU's on your TC? Could you supply any details on
the conversion? What was the reason for the change?
Rich
At 08:54 AM 5/24/00 , CFritz7001@aol.com wrote:
>Larry,
> I'm pretty sure tha "spacer" you refer to was intended to cut down on
>heat transfer from manifold to carbs. I've been running 1 1/2 carbs for
>years with just thin (about 1/32in. thick ) gaskets with no problems. I did,
>however make up a heat shield out of aluminum sheet metal to help avoid
>radiant heat from the exhaust manifold reaching the carbs. It fits between
>the intake manifold and the carbs, with a gasket (as above) on each side.
>I've never been aware of any problems I could trace to hot carbs with this
>setup.
>Carl Fritz TC # 6756
>Gainesville, FL
|