Rick:
somebody on the MC Chassis list posted a short table of efficiency
comparisons for MC drive systems. As I recall, the worst efficiency was
shaft-drive, and the 2nd-best was o-ring chain. The most efficient (least
power loss) was "standard" (non-O-ring) chain. Any experience using the
standard chain on your big-power machines?
Russ
-----Original Message-----
From: owner-land-speed@autox.team.net
[mailto:owner-land-speed@autox.team.net]On Behalf Of Rick Yacoucci
Sent: Tuesday, September 03, 2002 9:50 AM
To: >land-speedautox.team.net; ardunbill@webtv.net
Subject: Re: MC Chain
Looks like I am the ODDball here. I do not and will not ever use a Tsubaki
chain
I have broke 2 low mileage chains and they stretch like crazy.
I use the RK Oring chains never broke one, they stretch for the first 2 runs
but after that
they are low maintenance .These experiences are running these chains on a
250hp Hayabusa
and a 350hp Turbo GSXR1100 so bikes with less hp might be fine with the
Tsubaki.
Rick
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|