Larry, Brownfield heads are now Air Flow Research. Does the heads you
have use guide plates? The early brownfields use guide plates that are
different spacing than chevys. I have some old ones around the shop but
not enough to make a whole set. Off set lifters can only take some of
the misalignment out of the push rods. Doug Odom in big ditch
LGMCAFEE@aol.com wrote:
>
> List, I have bought a set of brownfield heads for a small block chevy and had
> a set of shaft mount rocker arms that I was going to use. When I started to
> install them they wouldn't fit, the valves are not in the stock location. Now
> my question is do I need offset lifters also and are they a standard offset
> or do I need a special lifter for this application. I am going to use roller
> lifters, I know this is basic stuff but I have never used offset valves.
> Thanks Larry Mac
///
/// land-speed@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe land-speed
///
/// or go to http://www.team.net/cgi-bin/majorcool
///
///
|