Too darn quiet on the list! What's going on? Everybody mad at each other?
Or what? Did my first TIG aluminum welding yesterday. What a hoot! Looked
like a bunch of angry chickens drizzled all over it. But today, a different
story! I cranked the amps up, polished the weld area with a scuff pad and
went at it. Most welds pretty good (oh, I am making my own twin throttle
body upper manifold for my twin turbo setup). I mean it looks homemade but
not too bad.
I need some wheels for my car. I need something 10 inches wide with 5 on
4.5 stud spacing and 6 inch (5.5 ok) backspacing. These are just to get the
car on some rear tires so I can determine the shock mounting height, etc.
It's already on the front tires. Anybody on the list have anything they
might part with? Oh, they need to have the 11/16 stud holes, not tapered
nuts, because I am using Mark Williams 5/8 inch studs (HUGE).
Well, this otta be nuf to start some conversation...especially my welding
expertise.
mayf
L.E. Mayfield
124 Maximillion Drive
Madison, Al. 35758-8171
1-256-837-1051
http://www.hsv.tis.net/~mayfield
DrMayf@AOL.com
lemay@hiwaay.net <<<<preferred
Bonneville Land Speed Racer, '66 Hydroplane Drag Boat (390 FE)
|