He uses the same third brake light that I used but his turn signal
modification is a very good one! I have mine wired to a mechanical switch
that is located on the brake pedal arm so that it will work if the pressure
switch fails and vice versa. Point is that this particular light assembly is
inexpensive and it looks great.
John Sims, BN6
Aberdeen, NJ
http://www.healey6.com
-----Original Message-----
From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
On Behalf Of Ron Mitchell
Sent: Tuesday, April 13, 2010 7:52 AM
To: Jaap Aeckerlin; Al Fuller; Healey forum
Subject: Re: [Healeys] brake switch
Hi all,
I'm suprised no one has mentioned Bob Slaters Third brake light set
up. He modifies the Third brake light to also serve as a turn signal light.
He uses a rubber magnet to hold the Third brake light in place. His set up
is
described on the AHC Southern Ontario Web Site. This Tiny URL will take
you the PDF file. http://tinyurl.com/yau5mbx which is found on
http://www.ahcso.com
I have a third light that I purchased from J. C.
Whitney/ http://tinyurl.com/ycmvqa9 I applied 2 inch masking tape to my
deck lid and did a bondo squeeze to get the mounting surface to conform to
the
deck lid I then use a strong rubber magnet to mount it. The wiring harness
was modified so I could remove the Third brake Light for Car Shows. I plan
on
changing to the Bob Slater Design. It offers a much cleaner appearance.
Ron
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|