The dust cover is a disk with a lip that fits over the yoke on the outside of
the housing; i.e. it's not pressed into the housing.
I called this 'flange' and 'yoke' in a previous post, it's actually the yoke
and the dust cover that slips over it. They look like one part and usually come
off together.
bs
----- Original Message -----
From: "Oudesluys" <coudesluijs@chello.nl>
To: "Mark Schneider" <mandmschneider@comcast.net>
Cc: healeys@autox.team.net
Sent: Wednesday, May 6, 2009 10:36:02 AM GMT -08:00 US/Canada Pacific
Subject: Re: [Healeys] Replacing pinion oil seal
To pull the pinion flange you probably do not need a puller, at the most
than the usual two legged afair to help a bit. It should not be a
pressed fit.
The pressed end plate you are referring to is probably the metal dust
cover that is pressed in over the seal it self. You can remove this dust
cover and the seal using a large screw driver. You probably need to
replace this cover as wel as the seal, as it is likely that it gets
damaged in the proces. The BJ7/8 partnumber is ATC7101 for the cover and
ATC 7085 for the seal.
Kees Oudesluijs
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|