Fellow Healeyoids,
I have been having a hell of a time trying to get my rubber seal installed
from the bottom of the windshield to the body on my 63 BJ7. Mind you, I
have three different windshield frames that I have tried. As well as three
different seal suppliers. They are Moss, AH Spares and Healey Surgeons.
Moss seemed to be the closest fit. I read in the archives the Healey
Surgeons is the best but I disagree thus far.
I have tried to "pull" it through after judiciously lubricating the channel
as well as the seal and tried three different lubes in three long different
attempts. Windex, silicone seal and lithium spray grease.
I have also tried to wedge it in just a little at a time with a thin
screwdriver. This worked better than "pulling" the pig-bitch seal through.
I have also tried to razor cut a small portion (1/16th ") off of the "T" in
the rubber seal to no avail. It then would not stay put.
As far as difficulty of operations is concerned, I put the rubber vent seals
in and it took about 10 minutes. That was super easy. This is one for the
hardest things that I have done on a frame up restoration. Harder than
getting the door gaps to look good.
I have two Healey buddies coming up this weekend and I will again attempt
this futile endeavor with them. That is, if we can find a sober enough
moment. My buddy is turning 50. Anyway, I'm looking for a detailed
description of how to perform this seemingly impossible task without
seriously maiming or killing anyone. Any and all advice is much
appreciated. Thanks in advance!
Randy
Healey-Archaeologist
63 BJ7
60 BT7
66 Cobra Replica
06 Mini Cooper S
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|