Hi Randy,
When I did my BT7, I lightly lubricated the seal with WD-40 and pulled it
through. When I got about halfway, I had to sort of push-pull the thing a
bit at a time, but it was relatively easy. Mine was supplied by Bob Yule at
the Healey AutoFarm. Could the channel in the windscreen be crimped
anywhere? Sounds unlikely. My only issue was getting the lip to lie flat
against the shroud when the windscreen was installed - I still have one
little hump that I caress down flat whenever I pass by the car!
Good luck with it.
Mirek
60 BT7
----- Original Message -----
From: "Randy Dickson" <rdickson@midwestarchaeology.com>
I have been having a hell of a time trying to get my rubber seal installed
from the bottom of the windshield to the body on my 63 BJ7.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|