One thing to check before you start trying to install that seal is that the
channel has not been damaged anywhere along its length. It is often
difficult to tell that it has been crushed at some point.
I ground the head of a large flat head nail so that it would just fit into
the groove and tap this along the entire length of the groove before
starting to install the seal.
Michael Salter
100 (1953) #174
AHX12 (1953)
Bugeye (1961)
http://www.netbug.net/blogmichael/?p=432
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|