Gentlemen,
I don't know why you fellows are all using these different wierd and
wonderful things to loosen and tighten your knockoffs. I have a 2 lb. Thor
copper/hide hammer I've been using for years around the shop, but using
ONLY
the hide end on the knockoff ears. The hammer has the mass and therefore
the
dead weight clout to do the job properly. The hide end eventually mushrooms
out to the point where it needs to be replaced. That has averaged about one
new one every 15 years or so, not a bad investment for a $35 tool. Of
course
the copper end is also very useful around the shop, being able to again
utilize its heavy dead blow weight to drift punches, chisels and the like.
Rich Chrysler
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|