Buy a cheap socket of whatever size is the next smaller (maybe
metric) from Harbor Fright or similar. Impact socket would be fine.
Drive it onto the nut and remove. Drive out the nut and repeat.
-Roland
BN1
On Wed, 29 Mar 2006 19:54:14 -0500, you wrote:
::I have run into a problem in disassembling the BJ7 and need some advice from
::the list. Five of the ten rear hub nuts have been "rounded off" by previous
::workers. The correct size socket just slips when you try and turn it. Any
::suggestions on removing these nuts or am I going to have to drill out the
::studs? TIA. Wendall Cross BJ7.
::
|