Go to Sears, and get a set of sockets for stripped nuts. --They cut in, when
turned. --You'll need a set of new nuts, but at least your studs will be OK.
--Can I say that on list?
Dave J.
----- Original Message -----
From: WHCross
To: list
Sent: Wednesday, March 29, 2006 7:54 PM
Subject: rear hub nuts
I have run into a problem in disassembling the BJ7 and need some advice
from
the list. Five of the ten rear hub nuts have been "rounded off" by previous
workers. The correct size socket just slips when you try and turn it. Any
suggestions on removing these nuts or am I going to have to drill out the
studs? TIA. Wendall Cross BJ7.
|