Incorrect. For the purest's. the TR3 caliper is a direct bolt on to the TR6
caliper bracket. The TR3 caliper, rotor and hub can be retained. To do the mod
one needs the TR6 upper A arms, vertical link, trunnion, and upper ball joint.
You can use all the urethane bushes from a "6", even on the lower-inner A
arms. One thing that must been retained from the "3" is the steering arm. The
hole for the tierod end is a different diameter. Luckily, they bolt right up.
The arms are of different heights (and lengths) which helps when you are
trying to adjust bump steer, but if using the TR6 steering arm you need a
tierod with a larger diameter pin. I think, but am not 100% sure my memory
serves me correctly, a Stag tierod will work.
Thanks - Ed -
--- On Wed, 6/3/09, Randall <tr3driver@ca.rr.com> wrote:
From: Randall <tr3driver@ca.rr.com>
Subject: Re: [Fot] TR3 suspension question
To: Fot@autox.team.net
Date: Wednesday, June 3, 2009, 12:15 PM
> Group: Just for the record, the TR6 suspension will bolt directly onto the
> TR3.
Correct, but don't forget the vertical link. If you keep the TR6 caliper
bracket, I believe you'll also need the later (smaller) rotor & caliper.
-- Randall
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.fot-racing.com
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|