I am pretty sure a TR6 is quite similar to a TR4, so maybe this helps.
This is how I do it...
Remove the headlights. Lay the hood in place on car. Reach in the
headlight holes to bolt up the brackets, a couple bolts per side. Open
hood, put the rest of the bolts in. Tighten them a little, but not so
much as the hood can't slide in the brackets. Close the hood, align as
needed, then tighten the bolts some more through the headlight holes so
it can't slide in the brackets. Open the hood, tighten the bolts to
proper torque. Reinstall headlights.
> -----Original Message-----
> From: fot-bounces+henry=henryfrye.com@autox.team.net
> [mailto:fot-bounces+henry=henryfrye.com@autox.team.net] On
> Behalf Of Chuck Arnold
> Sent: May 07, 2008 1:16 PM
> To: Friends; Triumph
> Subject: [Fot] Replacing TR6 hood
>
> Looking to see what tricks people use to re-install the hood
> after engine replacement when done as a one person job. I
> have done it several times, probably try different techniques
> each time, and get frustrated with all of them.
>
> --
> Chuck Arnold
> _______________________________________________
> http://www.team.net/donate.html
>
> Fot mailing list
> Fot@autox.team.net
> http://autox.team.net/mailman/listinfo/fot
>
> You are subscribed as henry@henryfrye.com
_______________________________________________
http://www.team.net/donate.html
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|