Try Stahl. http://www.stahlheaders.com/ When I was asking around about
6 months ago, some on the list recommended them. My project has stalled
somewhat so I have not purchased yet.
I am still looking also if anyone has a set to sell.
Thanks,
Greg
-----Original Message-----
From: fot-bounces+ablake2=austin.rr.com@autox.team.net
[mailto:fot-bounces+ablake2=austin.rr.com@autox.team.net] On Behalf Of
Cofrog@aol.com
Sent: Sunday, September 23, 2007 11:21 AM
To: FOT@Autox.Team.Net
Subject: [Fot] TR4 Headers
I am needing to replace the headers on my TR4A due to the flange
thickness
on the current ones being about half the flange thickness of the intake
manifold flange where both mount to the head. Some tabs have been
welded to the
flange of the header where the mounting points are to accommodate the
thickness
discrepancy But I am experiencing cracks in the intake manifold and
blame
this on the above.
I did some track time last week to test a new motor and another intake
manifold crack appeared. I have applied some JB Weld to it and loosened
the
mounting hardware by it. Hoping this "fix" will hold for the RMVR
event nest
weekend. Any input?
Has anyone had any experience with the headers that the big three sell?
Or
does anyone have a good set of headers that they want to sell?
Thanks,
Dan Forgey
http://www.aol.com
ablake2@austin.rr.com
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
_______________________________________________
http://www.team.net/donate.html
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|