I can make individual liner shims. That way you could raise any liner to
what ever height is needed. I'll look to see what S.S. shim material is
avail. I can cut it from this.
Mordy Dunst
Gasket Works USA, LLC
www.headgasket.com
626-358-1616 voice/fax
----- Original Message -----
From: <N197TR4@cs.com>
To: <gasket.works@gte.net>; <vinttr4@geneseo.net>
Cc: <alex3rail@home.com>; <thefryes@iconn.net>; <fot@autox.team.net>
Sent: Tuesday, May 29, 2001 2:25 PM
Subject: Figure Eight Gaskets
> Help!
>
> OK, I wasnt paying attention when we had earlier threads on this.
>
> But engine #1 seemed to be perfect in everyway. Engine #2 is just going to
> require a little more fiddling.
>
> I am going to bite the bullet and raise the liners up where they should
be. I
> am so close, timewise, to removal of liners anyway. I want to be able to
put
> my GasketWorks copper gasket back where it belongs.
>
> Mordy, have you made figure eights of various thickness? Jack, what have
you
> done? Anyone else?
>
> Joe
|