To: | gasket.works@gte.net, vinttr4@geneseo.net |
---|---|
Subject: | Figure Eight Gaskets |
From: | N197TR4@cs.com |
Date: | Tue, 29 May 2001 15:25:06 EDT |
Help! OK, I wasnt paying attention when we had earlier threads on this. But engine #1 seemed to be perfect in everyway. Engine #2 is just going to require a little more fiddling. I am going to bite the bullet and raise the liners up where they should be. I am so close, timewise, to removal of liners anyway. I want to be able to put my GasketWorks copper gasket back where it belongs. Mordy, have you made figure eights of various thickness? Jack, what have you done? Anyone else? Joe |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: Spitfire parts, Brad Kahler |
---|---|
Next by Date: | Re: Wheel Options, Mark J. Bradakis |
Previous by Thread: | Wheel Options, Barr, Scott |
Next by Thread: | Re: Figure Eight Gaskets, N197TR4 |
Indexes: | [Date] [Thread] [Top] [All Lists] |