I just got my 2000 1969 back together after a complete engine and trans
rebuild. 2 years, a bit of procrastinating and weather.
Today is is warm here in NJ, so I decided to do some final stuff. I started
her up, balanced the carbs, setthe timing and then went to bleed the clutch.
The pedal would not move, and won't unless I push VERY hard. It moved fine 3
weeks ago, and since it was low, I added fluid. DOT4.
Did I use the wrong fluid?
Do I need to rebuild the cylinder? I didn'ttouch the master of slave in this
rebuild.
Thanks in advance.
Jim Gammon
New Jersey
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|