A combination of compressed air through the back brake line outlet (near the
closed end) and whacking the closed end with a hard rubber mallet, while
placing the open end on a 2X4 on the floor, worked for me. Getting the assembly
back together after replacing the seals, was also a challenge. The seals didn't
want to go back in without rolling. After several attempts, the seals finally
seated and it started pumping fluid to the rear brakes as well as the front.
Now I have to work on the rear cylinders....
Steve Hill
Gilbert, AZ
480-545-1210
----- Original Message -----
From: "Fred Schroeder" <roadster@texoma.net>
To: "Allen Blackmon" <orangedawg@hotmail.com>; <Datsun-roadsters@autox.team.net>
Sent: Friday, June 28, 2002 10:08 PM
Subject: Re: Stuck piston in brake mc
> Place some rags on your work bench. Whack the open end straight down on the
> bench. The impact should knock the piston assy out. The rags are to keep
> from messing up the end of your M/C. Another way is to hold the M/C in one
> hand and beat on the open end with a rubber mallet.
>
> Best regards,
>
> Fred Schroeder
> Denison, TX
> SRL311-13359
> TDROC
> Reg e-mail sitsinwest@texoma.net
> Home page http://home.texoma.net/~sitsinwest
> ----- Original Message -----
> From: "Allen Blackmon" <orangedawg@hotmail.com>
> To: <Datsun-roadsters@autox.team.net>
> Sent: Friday, June 28, 2002 11:46 AM
> Subject: Stuck piston in brake mc
>
>
> > To List,
> >
> > I too am rebuilding my brake (tandem) mc. I disassembled most of it, but
> > the rear piston won't come out. The front piston fell out just fine. You
> > can push on the rear piston and it works like it's supposed to (you hear
> air
> > coming out of the reservior hole and the spring "springs and everything")
> > but it just won't come out of the mc. I have pounded on the end of the mc
> > with a hammer to try to get it to come out but no go. Is there something
> I
> > don't know? I have removed everything from the mc that you able to
> remove.
> > Will I have to use something that will eat the rubber seals so it will
> come
> > out? The problem seems to be the rearmost seal that is hanging up. But
> the
> > darn thing (piston assembly) won't come out.
> >
> > Any suggestions? Also, my shop manual mention the 510 mc on the same page
> > and the dual reservoir roadster. Are they the same?
> >
> > Allen
> > 1970 2000
> >
> >
> > _________________________________________________________________
> > Join the worlds largest e-mail service with MSN Hotmail.
> > http://www.hotmail.com
> >
> > /// datsun-roadsters@autox.team.net mailing list
> > /// Send admin requests to majordomo@autox.team.net or go to
> > /// http://www.team.net/cgi-bin/majorcool
> > /// Send list postings to datsun-roadsters@autox.team.net
>
> /// datsun-roadsters@autox.team.net mailing list
> /// Send admin requests to majordomo@autox.team.net or go to
> /// http://www.team.net/cgi-bin/majorcool
> /// Send list postings to datsun-roadsters@autox.team.net
/// datsun-roadsters@autox.team.net mailing list
|