Place some rags on your work bench. Whack the open end straight down on the
bench. The impact should knock the piston assy out. The rags are to keep
from messing up the end of your M/C. Another way is to hold the M/C in one
hand and beat on the open end with a rubber mallet.
Best regards,
Fred Schroeder
Denison, TX
SRL311-13359
TDROC
Reg e-mail sitsinwest@texoma.net
Home page http://home.texoma.net/~sitsinwest
----- Original Message -----
From: "Allen Blackmon" <orangedawg@hotmail.com>
To: <Datsun-roadsters@autox.team.net>
Sent: Friday, June 28, 2002 11:46 AM
Subject: Stuck piston in brake mc
> To List,
>
> I too am rebuilding my brake (tandem) mc. I disassembled most of it, but
> the rear piston won't come out. The front piston fell out just fine. You
> can push on the rear piston and it works like it's supposed to (you hear
air
> coming out of the reservior hole and the spring "springs and everything")
> but it just won't come out of the mc. I have pounded on the end of the mc
> with a hammer to try to get it to come out but no go. Is there something
I
> don't know? I have removed everything from the mc that you able to
remove.
> Will I have to use something that will eat the rubber seals so it will
come
> out? The problem seems to be the rearmost seal that is hanging up. But
the
> darn thing (piston assembly) won't come out.
>
> Any suggestions? Also, my shop manual mention the 510 mc on the same page
> and the dual reservoir roadster. Are they the same?
>
> Allen
> 1970 2000
>
>
> _________________________________________________________________
> Join the worlds largest e-mail service with MSN Hotmail.
> http://www.hotmail.com
>
> /// datsun-roadsters@autox.team.net mailing list
> /// Send admin requests to majordomo@autox.team.net or go to
> /// http://www.team.net/cgi-bin/majorcool
> /// Send list postings to datsun-roadsters@autox.team.net
/// datsun-roadsters@autox.team.net mailing list
|