Yes. But be aware the late series V onward has a 25 spline rather than the
10 spline that is on all of the other series Alpines which would require the
25 spline clutch disk and drive shaft. Pay attention to the clutch fork
pedestal also cause there is a tall and short, unless you use the same
(series V) clutch you may have to switch the pedestal too. I have heard of
some folks that didn't switch the pedestal (when required) and when the
transmission wouldn't go "all the way home", they tried to "pull' it up
with a bolt and broke their bellhousing. Good Luck
Russ
----- Original Message -----
From: <RSWiser@aol.com>
To: <alpines@autox.team.net>
Sent: Monday, November 18, 2002 7:21 PM
Subject: Engine Transmission combos
> Will a Series V transmission bolt up to a Series III engine.
|