The cold start valves on my Z-S's do not fully close when the knob is
pushed all the way home. It is almost like the cables need to push the
cam down at an angle which the cable attach point doesn't permit. I've
tried varying how much cable sheath is exposed below the little spring
clips without any particular success. If I expose a lot of sheath below
the clip, the excess cable gets sometimes snags the throttle linkage.
Exposing something like 3/8" of sheath below the clip permits the cable
to flex and the cam fails to move fully through its range of motion. Any
suggestions? Should the cold start valve move easily? It does seem sort
of stiff on each carb.
Rick Norris
|