Robert,
You did mean trim the speedo end of the cable not the angle drive end? The
speedo end has the plastic bush/stop that does not allow it to go further
into the sleeve. I did measure it and it is about 1/16" too long.
Bruce
----- Original Message -----
From: "Robert Liam Gannon" <trsix74@comcast.net>
To: "'Robert Liam Gannon'" <trsix74@comcast.net>; "'Bruce Moxon'"
<bamxn@triad.rr.com>; <6pack@autox.team.net>
Sent: Saturday, July 21, 2007 7:24 AM
Subject: RE: [6pack] Bouncing Speedo
> The 3/8's should be measured at the speedometer end. Insert the inner
> cable
> into the sheath until it will not go any further. At that point, you try
> turning the inner cable by hand to make sure it is in the angle drive.
> Once
> you are satisfied that it is where it should be, go to the end that
> inserts
> into the Speedo and measure. It should be no more than 3/8's. Guess I
> wasn't
> clear on that point. Sorry.
>
> Robert L. Gannon
> http://home.comcast.net/~trsix74/wsb/index.html
|